ISO 6194-1:2007(EN) Rotary shaft lip-type seals incorporating elastomeric sealing elements — Part 1: Nominal dimensions and tolerances

ISO 6194 was created by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 7, and Sealing devices. ISO 6194 consists of the following parts, under the general title Rotary shaft lip-type seals incorporating elastomeric sealing elements:
— Part 1: Nominal dimensions and tolerances
— Part 2: Vocabulary
— Part 3: Storage, handling and installation
— Part 4: Performance test procedures
— Part 5: Identification of visual imperfection

ISO 6194-1:2007(EN) Rotary shaft lip-type seals incorporating elastomeric sealing elements — Part 1: Nominal dimensions and tolerances
ISO 6194-1:2007 describes seals utilizing elastomeric sealing elements. They are considered suitable for use under low-pressure conditions
ISO 6194-1:2007 shows seal types and examples. It also specifies the nominal dimensions and tolerances of the seals, shafts and housings, as well as a dimensional identification code.
ISO 6194-2:2009(EN) Rotary shaft lip-type seals incorporating elastomeric sealing elements — Part 2: Vocabulary
ISO 6194-2:2009 establishes the appropriate vocabulary for seals utilizing elastomeric sealing elements where the terms and definitions given in ISO 5598 apply. These seals are considered suitable for use under low-pressure conditions
ISO 6194-3:2009(EN) Rotary shaft lip-type seals incorporating elastomeric sealing elements — Part 3: Storage, handling and installation
ISO 6194-3:2009 describes seals utilizing elastomeric sealing elements. They are considered suitable for use under low-pressure conditions
ISO 6194-3:2009 gives users of lip-type seals requirements and guidance on the careful storage, handling and proper installation of rotary shaft lip-type seals; attention is drawn to the hazards involved and ways of avoiding them.
ISO 6194-4:2009(EN) Rotary shaft lip-type seals incorporating elastomeric sealing elements — Part 4: Performance test procedures
ISO 6194-4:2009 describes seals utilizing elastomeric sealing elements. They are considered suitable for use under low-pressure conditions. ISO 6194-4:2009 specifies general test requirements for rotary shaft lip-type seals. The tests may be used for qualification purposes.
ISO 6194-5:2008(EN) Rotary-shaft lip-type seals incorporating elastomeric sealing elements — Part 5: Identification of visual imperfections
ISO 6194-5:2008 describes seals utilizing elastomeric sealing elements. They are normally considered suitable for use only at low pressures. ISO 6194-5:2008 defines and classifies typical surface imperfections that can impair the function of the seals and is intended as a convenience for purchasers and manufacturers in their discussions concerning the importance of these imperfections in different applications.
If you need more support with ISO 6194-1, ISO 6194-2, ISO 6194-3, ISO 6194-4 or ISO 6194-5, please contact us at +91-8595603096 or support@pacificcert.com